RTX 8930 Wireless Dect Headset
НАДVIEW
This manual explains how to operate the RTX SME VoIP DECT Headset (RTX8930) in generic mode, including power on/off, registration, basic call handling, volume control, and microphone muting.
Технические характеристики
- Модель: RTX8930 headset
- Регулировка громкости: Six volume steps (beeps indicate adjustments and limits)
- LED behavior (power/registration status): Blue LED blinks fast during initial signal detection/registration mode; after subscription it blinks with a 2-second interval
- Power-off key combination: Long-press AUX + VOL+ + VOL- for five seconds
Quick Setup & Use
- Включить: Нажмите AUX key. Wait for the blue LED to blink fast until a signal is detected; once subscribed, the voice prompt “Headset subscribed” plays and the blue LED changes to a 2-second interval.
- Initial registration: For first-time setup, switch the headset on; it enters registration mode automatically (blue LED blinking fast).
- Subsequent (re-)registration: Нажмите и удерживайте HOOK OFF вместе с ГРОМКОСТЬ+ и VOL- until the blue LED starts blinking fast. (Note: the blue LED will not enter registration mode if the unit is cradled and charging.)
- Ответьте на звонок: Нажимать HOOK OFF.
- Завершить звонок: Нажимать HOOK OFF снова.
- Adjust volume during a call: Нажимать ГРОМКОСТЬ+ увеличивать и VOL- уменьшаться.
- Отключить/включить микрофон: Нажимать MUTE to toggle mute on and off.Headset Operations Manual
Об этом документе
This document describes the features and functionalities available in the RTX SME VoIP DECT Headset. We describe how to operate the headset without going into details about its mechanical features. The reference for features and operation in this manual is RTX generic mode.
АудиторияЭто руководство предназначено как для обычных пользователей, так и для системных администраторов.
СокращенияДля целей настоящего документа используются следующие сокращения:
- ДЕКТ: Цифровые усовершенствованные беспроводные телекоммуникации
- ИПЭИ: Международная маркировка портативного оборудования
- МАК: Контроль доступа к среде
- АТС: Частная телефонная станция
Ссылки/сопутствующая документация
- [1]: How_To_Deploy_SME_Network_V1.3
- [2]: SME VoIP System Guide, Version 2.5
История документа
| Пересмотр | Автор | Дата выпуска | Комментарии |
|---|---|---|---|
| 0.1 | ТМС | 26-июля-2016 | Первоначальная версия. |
Торговая марка
| имя покупателя | РТХ | Уайлдикс | СНОМ | Strongbyte |
|---|---|---|---|---|
| Модель № | RTX8930headset | WAIR-Headset | А190 | VCV2840 headset |
| ХВИН | 8930В10 | WAIRV10 | 190В10 | 2840В10 |
| Торговая марка |
Основная операция
This section describes how to switch on and off the RTX8930 headset and how to register the unit on an RTX 8660 SME VoIP system.
How to Switch the Headset On/Off:
Выключение гарнитурыTo switch the headset off, long-press the AUX ключ вместе с ГРОМКОСТЬ+ и VOL- keys (press and hold the three keys for five seconds). The blue LED will give a short blink before switching off.
Registration Initial Registration
Последующие регистрацииIf the RTX8930 headset has already been registered on the same or another base system and needs to be re-registered, the required action is to press and hold the HOOK OFF ключ вместе с ГРОМКОСТЬ+ и VOL- keys until the blue LED starts blinking fast.
ПРИМЕЧАНИЕ: The blue LED will not start blinking in registration mode if the unit is cradled and charging. Please check the additional document via [2] for more information about terminal registration on a base system.
Звонки Операции
- Входящий звонок As the headset receives an incoming call, a ringtone will be played back
- Ответ на входящий звонок Чтобы ответить на входящий звонок, нажмите HOOK OFF ключ
- Отклонить входящий вызов It is not currently possible to reject an incoming call
- Завершение вызова To end an ongoing call, press the HOOK OFF ключ
- Громкость и отключение звука It is possible to adjust the earpiece volume up or down during calls by pressing the ГРОМКОСТЬ+ и VOL- keys, respectively. There are six volume steps. A beep is played back to indicate that the volume is adjusted. A higher frequency beep is played back when the volume cannot be adjusted further up or down.
- Отключение микрофона It is possible to mute the microphone during calls by pressing the MUTE key. The microphone is unmuted by pressing the MUTE key again. A voice prompt announcing “Mute on” is played back when mute is activated. A voice prompt announcing “Mute off” is played back when mute is deactivated.
Поиск неисправностей
- Headset doesn’t enter registration mode when re-registering: If you are cradled and charging, the blue LED will not start blinking fast in registration mode. Remove it from the cradle/charging and try again.
- No confirmation after switching on: После нажатия AUX, the blue LED should blink fast until a signal is detected. Once the headset locks onto a base, the voice prompt “Headset subscribed” should play and the LED should switch to blinking with a 2-second interval.
- Volume can’t be increased/decreased: The headset provides higher frequency beeps when the volume cannot be adjusted further up or down.
Документы/Ресурсы
 | 8930 Wireless Dect Headset |
Ссылки
- Руководство пользователяmanual.tools