Введение
This manual provides essential instructions for the setup, operation, and maintenance of your Pro-Ject RM 1.3 Turntable. Please read it thoroughly before use to ensure proper functionality and longevity of your device.
Содержимое упаковки
Перед началом установки убедитесь, что все компоненты присутствуют:
- Pro-Ject RM 1.3 Turntable Unit
- блюдо
- Приводной ремень
- Outboard 15V AC Motor
- Источник питания
- Sumiko Pearl Cartridge (pre-installed or separate)
- Removable RCA Cables
- Противовес
- Антискейтинг Вес
- Щуп для манометра
Инструкции по установке
Follow these steps carefully to set up your turntable:
- Распаковка: Carefully remove all components from the packaging. Retain packaging for future transport.
- Установка пластины: Place the platter onto the central spindle. Ensure it sits securely and rotates freely.
- Размещение двигателя: Position the outboard motor unit next to the turntable chassis. The motor pulley should align with the outer rim of the platter.
- Drive Belt Installation: Gently stretch the drive belt around the motor pulley and the outer rim of the platter. Ensure the belt is not twisted.
- Cartridge Installation (if not pre-installed): If your Sumiko Pearl cartridge is not pre-installed, carefully attach it to the tonearm headshell using the provided screws. Ensure correct alignment.
- Регулировка противовеса: Slide the counterweight onto the rear of the tonearm. Adjust it until the tonearm floats horizontally. Then, set the tracking force according to the cartridge manufacturer's recommendations (typically 1.8g for Sumiko Pearl). Use a stylus pressure gauge for accuracy.
- Anti-skating Adjustment: Attach the anti-skating weight to the tonearm's anti-skating mechanism. Adjust the setting to match the tracking force.
- Подключение к Ampпожизненнее: Connect the removable RCA cables from the turntable's output to the "Phono" input of your amplifier or a dedicated phono preamplifier. Ensure the ground wire is connected between the turntable and your ampпожизненно / доampУсилитель для минимизации шума.
Инструкция по эксплуатации
- Включение питания: Connect the power supply to the motor unit and a wall outlet. Press the power button on the motor unit to start the platter rotation.
- Выберите скорость: Most turntables offer 33 1/3 RPM and 45 RPM. Ensure the correct speed is selected for your record. (Refer to motor unit for speed selection mechanism, typically a switch or belt position change).
- Установить рекорд: Carefully place your vinyl record onto the platter.
- Нижний тонарм: Gently lift the tonearm using the cueing lever. Position the stylus over the desired track on the record. Slowly lower the cueing lever to allow the stylus to descend onto the record groove.
- Воспроизведение: The record will now play. Adjust the volume on your ampпожизненнее.
- Остановка воспроизведения: At the end of the record, or when you wish to stop, use the cueing lever to lift the tonearm from the record. Return the tonearm to its rest and secure it. Press the power button on the motor unit to stop the platter.
Обслуживание
- Очистка записей: Regularly clean your vinyl records using a dedicated record brush or cleaning solution to remove dust and static.
- Уход за стилусом: Use a soft stylus brush to gently clean the stylus tip before and after each play. Brush from back to front. Avoid touching the stylus with your fingers.
- Очистка проигрывателя: Wipe the turntable chassis and platter with a soft, dry, lint-free cloth. Avoid abrasive cleaners or solvents.
- Проверка ремня: Periodically check the drive belt for wear or stretching. Replace if necessary to maintain accurate playback speed.
Поиск неисправностей
Если у вас возникли проблемы с проигрывателем, ознакомьтесь со следующими распространенными проблемами и способами их решения:
| Проблема | Возможная причина | Решение |
|---|---|---|
| No power / Platter not spinning | Power cable disconnected; faulty power supply/motor; power outlet issue. | Ensure power cable is securely connected. Test the power outlet with another device. If the issue persists, contact support. |
| Жужжащий или гудящий звук | Ground wire not connected; proximity to other electronics; faulty cabling; internal wiring issue. | Ensure the ground wire is securely connected between the turntable and ampпожизненно / доamplifier. Move the turntable away from other electronic devices. Check RCA cables for damage. If hum persists, it may indicate an internal grounding issue requiring professional service. |
| Distorted sound / Skipping | Incorrect tracking force; worn or dirty stylus; damaged record; incorrect anti-skating. | Re-adjust tracking force and anti-skating. Clean the stylus. Inspect the record for damage. Replace stylus if worn. |
| Неправильная скорость воспроизведения | Incorrect speed selection; worn or stretched drive belt. | Verify the correct speed setting. Inspect and replace the drive belt if it appears worn or loose. |
Технические характеристики
| Особенность | Деталь |
|---|---|
| Бренд | Проект |
| Модель | 1.3 ринггитов |
| Размеры продукта | 15 x 4.33 x 13.78 дюйма |
| Вес товара | 11.15 фунта |
| Включенные компоненты | Sumiko Pearl Cartridge, removable RCA cables |
| Тип двигателя | Двигатель переменного тока |
| Формат сигнала | Аналоговый |
| Томtage | 15 вольт (переменный ток) |
| Цвет | Черный |
Гарантия и поддержка
For warranty information, please refer to the documentation provided with your purchase or visit the official Pro-Ject website. For technical support or service inquiries, please contact your authorized Pro-Ject dealer or the manufacturer's customer service department.
Сохраните документ, подтверждающий покупку, на случай гарантийных претензий.
