Введение
Thank you for choosing the STEINEL HS 152 XENO Sensor Halogen Floodlight. This product is designed to provide efficient and reliable outdoor lighting with integrated motion detection for enhanced security and convenience. Please read this manual carefully to ensure proper installation, operation, and maintenance of your floodlight.
Image: STEINEL HS 152 XENO Sensor Halogen Floodlight. This image shows the floodlight from a front-side angle, highlighting its compact design and the integrated motion sensor below the lamp жилье.
Инструкции по технике безопасности
WARNING: Risk of electric shock! Installation requires knowledge of electrical systems. Incorrect installation can lead to fire or electric shock. For your safety, always consult a qualified electrician if you have any doubts.
- Disconnect power at the main fuse or circuit breaker before installation or maintenance.
- Обеспечьте объем поставкиtage matches the floodlight's requirements (230-240V).
- Do not open the product housing unless specified in this manual.
- Не вносите никаких изменений в изделие.
- Держите детей подальше от упаковочных материалов.
- The floodlight becomes hot during operation. Avoid touching the lamp or housing immediately after use.
- Обеспечьте надлежащее заземление в соответствии с местными электротехническими нормами.
- This product is rated IP44 for protection against splashing water. Do not immerse in water.
Содержимое упаковки
Пожалуйста, убедитесь, что все детали на месте и не повреждены:
- 1x STEINEL HS 152 XENO Sensor Halogen Floodlight (with integrated R7s 150W halogen lamp)
- 1x Set of mounting screws and wall plugs
- 1x Set of cover plates for detection range adjustment
- 1x Руководство по эксплуатации
Установка
- Подготовка: Turn off the power supply at the main circuit breaker. Use a voltage tester to ensure the circuit is de-energized.
- Место установки: Choose a suitable mounting location, ideally 1.8m to 2.5m above the ground, where the sensor has an unobstructed view of the desired detection area. Avoid mounting near heat sources or objects that might cause false triggers (e.g., moving branches, busy roads).
- Бурение: Mark the drilling points using the floodlight's mounting plate as a template. Drill holes and insert wall plugs.
- Проводка: Connect the electrical wires (Live, Neutral, Earth) from your mains supply to the corresponding terminals inside the floodlight's wiring compartment. Ensure all connections are secure.
- Mounting the Floodlight: Secure the floodlight to the wall using the provided screws. Adjust the floodlight head to the desired angle.
- Включение питания: Restore power at the main circuit breaker. The floodlight will perform a brief self-test.
Операция
The STEINEL HS 152 XENO floodlight features an integrated passive infrared (PIR) motion sensor. When motion is detected within its adjustable range and the ambient light level falls below the set twilight threshold, the floodlight will automatically switch on for the pre-set duration.
Регулировка датчика
The sensor has three main adjustment controls, typically located on the underside of the sensor head:
- Range (Reach): Adjusts the detection distance, up to 12 meters, limitable to approximately 5 meters using the included cover plates. Turn the dial to increase or decrease the range.
- Twilight Threshold (Lux): Sets the ambient light level at which the sensor becomes active. Turn towards the sun symbol for daylight operation (test mode) or towards the moon symbol for activation only in darkness.
- Time Setting (Time): Determines how long the light remains on after motion is detected. Adjust the dial to set the desired duration.
The detection angle is 180° with an opening angle of 90°. Use the provided cover plates to precisely mask out areas you do not wish to be detected, such as public pathways or neighboring properties.
Обслуживание
Уборка
Clean the floodlight and sensor lens regularly with a soft, damp cloth. Do not use abrasive cleaners or solvents, as these can damage the surfaces or the sensor lens.
Lamp Замена
WARNING: Disconnect power before replacing the lamp.
- Ensure the floodlight is cool before handling.
- Осторожно откройте л.amp жилье.
- Remove the old R7s halogen lamp.
- Insert a new R7s 150W halogen lamp. Ensure it is correctly seated.
- Закройте лamp housing securely.
- Восстановите подачу электроэнергии.
Поиск неисправностей
| Проблема | Возможная причина | Решение |
|---|---|---|
| Свет не включается. | Нет электропитания. Lamp неисправен. Twilight threshold set too high (daylight). Sensor range too low. | Проверить автоматический выключатель. Заменить лamp. Adjust twilight setting towards 'moon' symbol. Increase sensor range. |
| Свет горит постоянно. | Continuous motion in detection area. Датчик неисправен. | Adjust sensor range or mask detection area. Обратитесь в службу поддержки клиентов. |
| Свет включается без видимого движения. | False triggers (e.g., heat sources, small animals, moving branches). | Adjust sensor angle, reduce range, or use cover plates to mask problematic areas. |
Технические характеристики
| Бренд: | СТАЙНЕЛЬ |
| Номер модели: | 632113 |
| Цвет: | Черный (Note: Product title indicates 'ws' for white, but specifications list 'Noir' for black.) |
| Особая особенность: | Датчик движения |
| Материал: | Стекло |
| Источник питания: | Проводной электрический |
| Тип источника света: | Галоген |
| Количество источников света: | 1 |
| Томtage: | 230 Вольт |
| Ватtage: | 150 Вт |
| Класс защиты: | IP44 |
| Угол обнаружения: | 180° (Opening angle 90°) |
| Макс. Диапазон обнаружения: | 12 метров (с возможностью регулировки до 5 метров) |
Гарантия и поддержка
For warranty information and technical support, please refer to the official STEINEL website or contact your local STEINEL distributor. Keep your purchase receipt as proof of purchase.
STEINEL Contact Information:
- Official STEINEL Webсайт
- Refer to product packaging for specific regional support contacts.
