Philips 12361B1 H9 Standard Halogen Headlight Bulb Instruction Manual

Введение

This manual provides essential information for the safe and effective installation, operation, and maintenance of your Philips 12361B1 H9 Standard Halogen Headlight Bulb. Philips Standard range bulbs are designed to offer Original Equipment quality, ensuring reliable performance for your vehicle's lighting system.

Информация по безопасности

• Используйте защитную одежду: Always wear appropriate eye protection and gloves when handling automotive bulbs.
• Избегайте прикосновения к стеклу: Never touch the glass part of the bulb with bare hands. Oils from your skin can create hot spots, leading to premature bulb failure. Use gloves or a clean cloth/paper towel if contact is unavoidable.
• Электробезопасность: Ensure the vehicle's ignition is off and the headlights are switched off before attempting any bulb replacement. Disconnect the battery if necessary to prevent electrical shock.
• Правильная утилизация: Утилизируйте старые лампочки в соответствии с местными правилами.
• Предупреждение о предложении 65: Данный продукт может содержать химические вещества, которые, согласно законодательству штата Калифорния, вызывают рак, врожденные дефекты или другие нарушения репродуктивной функции. Для получения дополнительной информации посетите [ссылка]. www.P65Warnings.ca.gov.

Содержимое упаковки

• 1 x Philips 12361B1 H9 Standard Halogen Headlight Bulb

Технические характеристики

Настройка и установка

Replacing a headlight bulb can vary depending on your vehicle's make and model. Always consult your vehicle's owner's manual for specific instructions and safety precautions before proceeding. The following steps provide a general guide.

Рекомендуемые инструменты и материалы:

• New Philips H9 Halogen Headlight Bulbs (recommended to replace in pairs)
• Protective gloves (latex or nitrile)
• Чистая ткань или бумажное полотенце
• Screwdriver or wrench (if required by your vehicle)

Пошаговая установка:

1. Подготовьте свой автомобиль: Park your vehicle on a level surface, turn off the engine, engage the parking brake, and turn off all lights. Allow the engine to cool down if it has been recently running.
2. Найдите блок фар: Open the hood of your vehicle. Identify the back of the headlight assembly. Access may require removing other components like air intake ducts or battery covers, depending on your vehicle model.
3. Отсоедините электрический разъем: Осторожно отсоедините электрический разъем от задней части старой лампочки. Обычно для этого нужно нажать на язычок и потянуть.
4. Извлеките старую лампочку: The bulb is typically held in place by a retaining clip or a twist-lock mechanism. Release the clip or twist the bulb counter-clockwise to remove it from the housing.
5. Inspect the Old Bulb: Note the orientation of the old bulb to ensure the new one is installed correctly.
6. Установите новую лампочку:
   

   Изображение: Крупный план view of the Philips H9 Halogen Headlight Bulb, showing the glass capsule and base connector.
   

   Изображение: подробное view of the Philips H9 Halogen Headlight Bulb's base, highlighting the electrical contacts and mounting flange.

   Holding the new Philips H9 bulb by its plastic base (wearing gloves), carefully insert it into the headlight housing. Align the tabs on the bulb with the slots in the housing. Twist clockwise or re-engage the retaining clip until the bulb is securely seated.

7. Подключите электрический разъем обратно: Plug the electrical connector back onto the new bulb until it clicks into place.
8. Проверьте свет: Turn on your vehicle's headlights to ensure both the newly installed bulb and the other headlight (if replaced in pairs) are functioning correctly. Check both low and high beams.
9. Adjust Headlight Aim (if necessary): If your headlights appear misaligned after replacement, consult your vehicle's owner's manual or a qualified technician for proper aiming procedures.

Важный: It is highly recommended to replace headlight bulbs in pairs. As bulbs age, their light output diminishes. Replacing both at the same time ensures a symmetric light beam and consistent visibility on the road, enhancing safety.

Operating Your Headlights

Your Philips H9 Halogen Headlight Bulbs are designed for standard vehicle operation. Use your vehicle's headlight switch to control low beams, high beams, and parking lights as appropriate for driving conditions. Always use low beams when driving in traffic or when approaching other vehicles to avoid dazzling other drivers.

Image: A car driving at night, illuminated by bright, clear headlights, demonstrating enhanced visibility.

Обслуживание

• Регулярный осмотр: Periodically check your headlights for proper function. Ensure both low and high beams are working and that the light output is consistent.
• Clean Headlight Lenses: Keep your vehicle's headlight lenses clean from dirt, grime, and haze. Use a soft cloth and automotive-approved cleaner to maintain optimal light transmission.
• Заменить парами: As mentioned in the installation section, it is best practice to replace both headlight bulbs at the same time to ensure balanced light output and prevent one side from being dimmer than the other.
• Избегайте загрязнения: When handling bulbs for inspection or replacement, always use gloves to prevent skin oils from transferring to the glass.

Поиск неисправностей

Лампа не горит:

• Проверьте подключение: Ensure the electrical connector is securely attached to the bulb.
• Проверьте наличие мест: Make sure the bulb is properly seated and twisted/clipped into the headlight housing.
• Проверьте предохранитель: Check your vehicle's fuse box for a blown headlight fuse. Consult your vehicle's owner's manual for fuse box location and diagram.
• Test with Another Bulb: If possible, test the circuit with a known working bulb to rule out a vehicle wiring issue.

Тусклый или неравномерный световой поток:

• Заменить парами: If only one bulb was replaced, the new bulb might appear brighter than the older, still-functioning bulb. Replace both for balanced light.
• Чистые линзы: Ensure headlight lenses are clean and free of haze or oxidation.
• Check Aim: Headlights may need to be re-aimed after bulb replacement.

Incorrect Bulb Fit:

Подтвердите соответствие: When selecting a replacement bulb, always confirm the specific ПОЗИЦИЯ (e.g., fog light, low beam, high beam) and any ПРИМЕЧАНИЯ provided by the manufacturer or an automotive parts finder. For some vehicles, a bulb type might fit certain positions but not all. The POSITION and NOTES ensure an exact fit for your vehicle.

Гарантия и поддержка

For warranty information, technical support, or further assistance with your Philips 12361B1 H9 Standard Halogen Headlight Bulb, please visit the official Philips Automotive Lighting webили обратитесь в службу поддержки клиентов. Сохраните чек в качестве подтверждения покупки.

Official Philips Automotive Webсайт: www.philips.com/automotive