DUALSKY PCU 80HV

DUALSKY PCU 80HV Brushless ESC Instruction Manual

Model: PCU 80HV

1. Введение

The DUALSKY PCU 80HV is a high-performance 80A brushless Electronic Speed Controller (ESC) designed for multi-rotor aircraft, agricultural plant protection UAVs, and aerial photography drones. It supports a wide voltage range of 5-14S LiPo batteries and features a 32-bit ARM Core for precise motor control. This manual provides essential information for the safe and effective setup, operation, and maintenance of your PCU 80HV ESC.

DUALSKY PCU 80HV 80A Brushless ESC
Figure 1: DUALSKY PCU 80HV 80A Brushless ESC. This image shows the top-down view of the ESC with its heat sink fins and wiring.

2. Технические характеристики

Below are the detailed specifications for the DUALSKY PCU 80HV ESC:

DUALSKY PCU 80HV Dimensions and Specifications Table
Figure 2: Detailed dimensions and technical specifications for the DUALSKY PCU 80HV ESC. This image includes a diagram with measurements and a comprehensive table of electrical and operational parameters.
ОсобенностьСпецификация
Название брендаДВОЙНОЙ НЕБЕСНЫЙ
Номер моделиPCU 80HV
Размеры (ДxШxВ)80 x 36 x 23 мм (3.12 x 1.30 x 0.93 дюйма)
Weight (without wires)110 г
LiPo Cell Count5-14S (18.5-44.4V)
Постоянный ток80А
Всплеск тока100А
Сопротивление (R)0.0017 Ом
Входной сигналШИМ
частота сигналаДо 450 Гц
Battery Eliminator Circuit (BEC)Нет BEC
ПрограммированиеПрограммирование не требуется
High Response System (HRS)Да
Активный тормозДа
Система отсчета времениAuto timing
Мягкий стартПредустановленный
УскорениеПредустановленный
Низкая громкостьtage ОтсечкаПредустановленный
ЗапускатьПредустановленный
Защита от перегреваДа
Защита от воды и пылиДа (IP56)
РадиаторДа
Входной провод12AWG, 760 мм
Выходной провод14AWG, 130 мм
Сигнальный проводJR, 970mm
ПриложенияMulti-rotor, Agricultural Plant Protection UAV, Aerial Photography UAV, high poles motors, shaft thrust up to 15 KGS.

3. Настройка

Careful installation and wiring are crucial for the safe and optimal performance of your ESC. Refer to the diagram in Figure 2 for visual guidance on dimensions and wire lengths.

3.1 Подключение проводки

  1. Подключение двигателя: Connect the three output wires (14AWG, 130mm) from the ESC to the three phase wires of your brushless motor. The order of connection may affect motor rotation direction. If the motor spins in the wrong direction, swap any two of the ESC's output wires.
  2. Подключение аккумулятора: Connect the two input wires (12AWG, 760mm) from the ESC to your LiPo battery. Ensure correct polarity: red wire to positive (+), black wire to negative (-). This ESC supports 5-14S LiPo batteries.
  3. Подключение приемника/контроллера полета: Connect the signal wire (JR, 970mm) from the ESC to the appropriate throttle channel on your receiver or flight controller.
  4. BEC (схема отключения батареи): The PCU 80HV ESC does NOT include a built-in BEC. You MUST use an external BEC or a separate power source to supply power to your receiver and flight controller. Failure to do so will result in no power to your control system.

3.2 Монтаж

Mount the ESC securely in a location that allows for adequate airflow to the heat sink. Avoid mounting it in enclosed spaces where heat can build up. The dimensions are 80x36x23mm. Use appropriate fasteners or double-sided tape to secure the ESC, ensuring it is protected from vibrations and physical damage.

4. Инструкция по эксплуатации

The DUALSKY PCU 80HV ESC is designed for ease of use with "No programming needed" as per its specifications. It features preset settings for soft start, acceleration, low voltage cut-off, and start-up, along with auto timing and active brake functions.

4.1 Initial Power-Up and Throttle Calibration (Recommended)

Although no programming is needed, performing a throttle range calibration with your transmitter is highly recommended for optimal performance and safety:

  1. Ensure your transmitter is powered on and the throttle stick is at its maximum position.
  2. Подключите основную батарею к регулятору скорости.
  3. Listen for a series of beeps from the motor, indicating the ESC has detected the maximum throttle signal.
  4. Move the throttle stick to its minimum position.
  5. The ESC will emit another series of beeps, confirming the minimum throttle signal has been learned. The ESC is now armed and ready for use.

4.2 Нормальная работа

After calibration, follow these steps for normal operation:

  1. Включите передатчик.
  2. Ensure the throttle stick is at its minimum position.
  3. Подключите основную батарею к регулятору скорости.
  4. Wait for the ESC to initialize and arm (indicated by beeps).
  5. Slowly advance the throttle stick to control the motor speed.

The ESC features Active Brake for quick motor stops and Overheat Protection for safe operation under demanding conditions.

5. Техническое обслуживание

Regular maintenance helps ensure the longevity and reliable performance of your DUALSKY PCU 80HV ESC.

  • Инспекция: Periodically inspect the ESC, wires, and connectors for any signs of damage, fraying, or corrosion. Ensure all connections are secure.
  • Уборка: Keep the ESC clean and free from dirt, dust, and debris. While the ESC is rated IP56 for water and dust resistance, excessive build-up can still hinder heat dissipation. Use a soft brush or compressed air for cleaning.
  • Охлаждение: Ensure the heat sink remains unobstructed and that there is adequate airflow around the ESC during operation to prevent overheating.
  • Хранилище: When not in use, store the ESC in a dry, cool place away from direct sunlight and extreme temperatures.

6. Поиск Неисправностей

If you encounter issues with your DUALSKY PCU 80HV ESC, consider the following troubleshooting steps:

  • Motor not spinning or erratic behavior:
    • Check all wiring connections between the ESC, motor, battery, and receiver/flight controller. Ensure they are secure and correctly polarized.
    • Verify that the battery is fully charged and capable of supplying the required current.
    • Perform a throttle range calibration as described in Section 4.1.
    • Ensure your transmitter's throttle channel is correctly configured and not reversed.
    • Осмотрите двигатель на предмет наличия физических повреждений или препятствий.
  • Перегрев регулятора скорости:
    • Ensure the ESC is mounted in a location with sufficient airflow.
    • Check for any obstructions on the heat sink.
    • Verify that the motor and propeller combination is not drawing excessive current, which can overload the ESC.
    • Убедитесь, что аккумулятор vol.tage is within the supported 5-14S range.
  • No power to receiver/flight controller:
    • Remember that this ESC does NOT have a built-in BEC. Ensure you have an external BEC or a separate power source correctly connected to your receiver/flight controller.
    • Check the power connections to your external BEC or separate power source.

7. Советы пользователю

Никаких конкретных советов для пользователей не было предоставлено.views or Q&A content. However, general best practices for ESCs include:

  • Always perform a throttle calibration when setting up a new ESC or changing transmitters.
  • Ensure all solder joints are clean and strong to prevent intermittent connections or power loss.
  • Use appropriate wire gauges for battery and motor connections to minimize resistance and heat generation.
  • Regularly check battery connectors for wear and tear.

8. Гарантия и поддержка

For warranty information and technical support, please refer to the DUALSKY official webна сайте или обратитесь к авторизованному дилеру. Сохраните чек о покупке для предъявления гарантийных претензий.

Связанные документы - PCU 80HV

Предварительноview Инструкция по эксплуатации регулятора скорости Dualsky Summit Series ESC — функции, настройка и устранение неполадок.
Comprehensive instruction manual for the Dualsky Summit Series ESC, covering features, wiring diagrams, initialization, calibration, operation settings, protection features, status codes, precautions, and warranty information for models SUMMIT 120, 100HV, and 120HV.
Предварительноview Руководство по программированию бесколлекторного регулятора скорости DUALSKY XController
В данном руководстве содержатся подробные инструкции по программированию бесколлекторного электронного регулятора скорости (ESC) DUALSKY XController для радиоуправляемых моделей, включая настройки, нормальную работу и процедуры программирования.
Предварительноview Руководство по эксплуатации регулятора скорости Summit X Series — Dualsky Advanced Power Systems
Полное руководство по эксплуатации регулятора скорости Dualsky Summit X Series с подробным описанием основных функций, параметров программирования, схем электропроводки, сигналов состояния, телеметрии, гарантии и отказа от ответственности. Оптимизировано для любителей радиоуправляемых моделей.
Предварительноview Инструкция по эксплуатации бесщеточного регулятора скорости DUALSKY XController Lite
Инструкция по эксплуатации бесколлекторного регулятора скорости DUALSKY XController Lite с подробным описанием технических характеристик, параметров программирования и основных настроек для различных моделей, включая XC-65-Lite, XC-45-Lite, XC-22-Lite и XC-12-Lite.
Предварительноview Руководство по эксплуатации регулятора скорости Dualsky Summit X Series
Полное руководство по эксплуатации электронного регулятора скорости (ESC) Dualsky Summit X Series с подробным описанием основных функций, схем электропроводки, параметров программирования, тональных сигналов рабочего состояния, возможностей телеметрии, индикации неисправностей, отказом от ответственности и информацией о гарантии.
Предварительноview Краткое руководство Dualsky TELElink для SUMMIT X — настройка и подключение
Краткое руководство по регуляторам скорости Dualsky TELElink для SUMMIT X, подробно описывающее содержимое комплекта, схемы электропроводки, настройку телеметрии для приемников Futaba, Jeti и Spektrum, а также режимы работы USB для настройки параметров и обновления прошивки.