CREWORKS 10L Ultrasonic Cleaner Instruction Manual

1. Введение

Thank you for choosing the CREWORKS 10L Ultrasonic Cleaner. This professional-grade unit is designed for efficient and thorough cleaning of various items using ultrasonic cavitation. This manual provides essential information for safe operation, maintenance, and troubleshooting to ensure optimal performance and longevity of your device. Please read these instructions carefully before first use and retain them for future reference.

2. Инструкции по технике безопасности

• Всегда подключайте устройство к заземленной розетке.
• Не используйте устройство, если в резервуаре нет жидкости.
• Убедитесь, что шнур питания не поврежден, и избегайте размещения на нем тяжелых предметов.
• Keep the unit away from water splashes and do not immerse the main body in water.
• Не прикасайтесь к вилке электропитания мокрыми руками.
• Отключите устройство от сети перед чисткой или обслуживанием.
• Хранить в недоступном для детей и домашних животных месте.
• Use appropriate cleaning solutions. Avoid flammable, corrosive, or highly acidic/alkaline liquids.
• Do not operate the unit continuously for extended periods without allowing it to cool down.
• Обеспечьте надлежащую вентиляцию вокруг устройства во время работы.

3. Продукт закончилсяview

The CREWORKS 10L Ultrasonic Cleaner features a robust 304 stainless steel tank and housing, designed for durability and resistance to corrosion. It incorporates a 240W ultrasonic transducer for powerful cleaning and a 300W heater for optimal temperature control. The intuitive analog control panel allows for precise adjustment of cleaning parameters.

This image shows the CREWORKS 10L Ultrasonic Cleaner from the front, highlighting its stainless steel construction and the analog control panel with two rotary knobs and toggle switches.

Ключевые компоненты:

• Бак из нержавеющей стали: 10-liter capacity, made from high-quality 304 stainless steel.
• Крышка: Reinforced lid to reduce noise during operation.
• Панель управления: Analog dials for temperature and timer, with toggle switches for special modes.
• Сливной клапан: Convenient brass valve for easy liquid drainage.
• Интегрированные ручки: For easy and safe transport of the unit.
• Корзина для уборки: Removable stainless steel basket for holding items during cleaning.

A close-up shot of the control panel, clearly showing the temperature and timer dials, along with the power switch and mode selection buttons for Degas and Half-Wave (Delicate) cleaning.

This image shows the ergonomic integrated side handle for easy portability and the robust stainless steel basket designed to hold items during cleaning.

4. Настройка

1. Распаковка: Carefully remove the ultrasonic cleaner from its packaging. Inspect the unit for any signs of damage.
2. Размещение: Place the unit on a stable, level, and dry surface. Ensure there is adequate ventilation around the cleaner.
3. Заполнение бака: Откройте крышку и наполните резервуар из нержавеющей стали подходящим чистящим раствором. Убедитесь, что уровень жидкости находится между отметками MIN и MAX. Не переполняйте резервуар.
4. Подключение питания: Подключите шнур питания к заземленной электрической розетке.
5. Загрузка предметов: Place the items to be cleaned into the stainless steel basket. Lower the basket into the tank, ensuring items are fully submerged but not touching the bottom of the tank directly.

5. Инструкция по эксплуатации

Основная операция:

1. Включение питания: Переведите главный выключатель питания в положение «ВКЛ».
2. Установить температуру: Rotate the 'TEMPERATURE' knob to set the desired cleaning temperature between 20°C and 80°C. The 300W heater will begin warming the solution. For faster heating, you may use pre-warmed water.
3. Установить таймер: Rotate the 'TIME' knob to set the desired cleaning duration, from 1 to 30 minutes.
4. Начать очистку: The ultrasonic cleaning will start automatically once the timer is set. The unit will stop when the timer counts down to zero.

Специальные режимы:

• Функция Дега: Activate the 'DEGAS' toggle switch. This function expels air bubbles from the cleaning liquid, maximizing cavitation effectiveness for deeper cleaning. It is recommended to run Degas for a few minutes before starting a cleaning cycle, especially with fresh solution.


An illustrative image demonstrating the Degas function, where air bubbles are expelled from the cleaning solution to enhance cavitation and cleaning efficiency.

• Delicate (Half-Wave) Mode: Activate the 'SEMI-WAVE' toggle switch. This mode modulates the ultrasonic power, providing a gentler cleaning action suitable for fragile items such as delicate jewelry, PCBs, or lenses, preventing potential damage.


This image visually represents the Delicate (Half-Wave) mode, indicating how ultrasonic power is modulated to provide a gentler cleaning action for sensitive items.

После очистки:

1. When the cleaning cycle is complete, turn off the unit.
2. Carefully lift the basket out of the tank.
3. Rinse the cleaned items with clean water and dry them thoroughly.
4. Слив бака: Place a suitable container under the drain valve. Open the drain valve to empty the cleaning solution. Close the valve once the tank is empty.

A visual comparison showing the effectiveness of the ultrasonic cleaner on various items, with 'Before' and 'After' images of dirty eyeglasses, a used razor blade, and a tarnished printed circuit board.

6. Техническое обслуживание

• Очистка устройства: After each use, especially after draining, wipe the inside of the tank and the exterior of the unit with a soft, damp ткань. Не используйте абразивные чистящие средства и не погружайте устройство в воду.
• Уход за корзиной: Clean the stainless steel basket regularly to prevent residue buildup.
• Хранилище: Store the ultrasonic cleaner in a cool, dry place when not in use. Ensure the tank is empty and dry.
• Регулярные проверки: Periodically inspect the power cord and plug for any damage. Ensure the drain valve operates smoothly.

7. Поиск Неисправностей

8. Технические характеристики

A diagram showing the external dimensions of the ultrasonic cleaner (33x27x27.5 cm) and the internal dimensions of the tank (30x24x15 cm) and basket (28.3x21.5x12 cm).

9. Гарантия и поддержка

CREWORKS products are manufactured to high-quality standards. For warranty information or technical support, please refer to the documentation included with your purchase or contact your retailer. Keep your purchase receipt as proof of purchase for any warranty claims.