HelloBaby AC

HelloBaby Baby Monitor Charger Instruction Manual

For Models HB6550, HB6560, HB50-5V, and other 2022+ HelloBaby Monitors

1. Заview

This official HelloBaby replacement charger is designed to provide reliable power to your compatible HelloBaby baby monitor and camera units. It serves as an ideal accessory for replacing a lost or damaged power cord adapter, ensuring continuous monitoring of your little one.

Основные характеристики:

  • Широкая совместимость: Specifically designed for HelloBaby baby monitors and cameras from 2022 and later versions, including HB6550, HB6550-2, HB6560, HB40, HB6339, HB6336, and HB6250.
  • Характеристики мощности: Input: 100-240V, 50/60 Hz; Output: 5.0V, 1A.
  • Оптимальная длина: Features a 6.6ft (approximately 2 meters) cable, matching the original power cord length for flexible placement.
  • Сертифицированная безопасность: Equipped with charging safety certification to ensure safe operation.
HelloBaby baby monitor charger with a warning tag about strangulation hazard.

Figure 1: HelloBaby replacement charger with its attached warning tag. Always keep cords out of reach of children.

2. Инструкции по настройке

Follow these steps to properly set up your HelloBaby replacement charger:

  1. Проверка совместимости: Ensure your HelloBaby monitor model is listed as compatible (e.g., HB6550, HB6560, HB50-5V, HB40, HB6339, HB6336, HB6250). If unsure, refer to your monitor's manual or contact HelloBaby support.
  2. Connect to Monitor/Camera: Insert the small connector end of the charger cable into the designated power port on your HelloBaby baby monitor or camera unit.
  3. Подключитесь к розетке: Plug the AC adapter end of the charger into a standard 100-240V wall outlet.
  4. Подтвердите оплату: The monitor or camera should indicate that it is receiving power or charging (e.g., a charging icon on the screen or an LED indicator).
Close-up of the power adapter showing input and output specifications: 100-240V, 50-60Hz, 0.2A input, and 5.0V, 1.0A output.

Figure 2: Power adapter details, confirming 5V 1A output for safe charging.

Video 1: This video demonstrates the HelloBaby monitor's features, including its setup and use, which involves connecting the power adapter for charging and continuous operation.

3. Операция

Once connected, the charger will automatically begin supplying power to your HelloBaby monitor or camera. For optimal battery life, it is recommended to keep the monitor plugged in when not in active use or when the battery level is low. The charger is designed for continuous use.

4. Уход и обслуживание

To ensure the longevity and safe operation of your charger, please observe the following:

  • Обращаться с осторожностью: Avoid bending or twisting the cable excessively, especially near the connectors, to prevent internal wire damage.
  • Хранить в сухом месте: Do not expose the charger to water or excessive humidity.
  • Очищайте осторожно: If cleaning is necessary, unplug the charger from the wall and wipe it with a dry, soft cloth. Do not use liquid cleaners.
  • Хранилище: Если зарядное устройство не используется, храните его в прохладном, сухом месте, вдали от прямых солнечных лучей и экстремальных температур.
  • Предупреждение о безопасности: The charger cable includes a warning tag regarding strangulation hazards. Always keep the cord out of reach of children (more than 3 feet / 0.9 meters away). Do not remove this tag.

5. Поиск Неисправностей

If your monitor or camera is not charging, perform the following diagnostic steps:

  • Проверьте розетку: Убедитесь в работоспособности розетки, подключив к ней другое устройство.
  • Проверьте соединения: Verify that both ends of the charger are securely plugged into the monitor/camera and the wall outlet.
  • Swap Cords (if applicable): If you have two original power cords (e.g., one for the monitor, one for the camera), try swapping them between devices. If a device works with the swapped cord, then the original cord for that device may be faulty, and this replacement charger is needed.
  • Связаться со службой поддержки: If the issue persists after these steps, contact HelloBaby customer support for further assistance or warranty claims.

6. Технические характеристики продукта

ОсобенностьДеталь
БрендHelloBaby
Номер моделиAC
Тип разъемаAC
Совместимые устройстваHelloBaby Baby Monitors (HB6550, HB6550-2, HB6560, HB50, HB6339, HB6250, HB40, HB6336)
Vol входtage100-240 В (переменный ток)
Выход Voltage5.0В
Ampярость1 Amps
Ватtage5 Вт
Длина кабеля6.6 фута (приблизительно 2 метров)
Специальная характеристикаЗащита от короткого замыкания
ЦветБелый
Вес товара0.317 унции

7. Информация о гарантии

This HelloBaby replacement charger comes with a one-year warranty from the date of purchase. This warranty covers manufacturing defects and ensures the product functions as intended under normal use. Please retain your proof of purchase for any warranty claims.

8. Поддержка клиентов

For any questions, concerns, or technical assistance regarding your HelloBaby baby monitor charger, please contact HelloBaby customer support. You can typically find contact information on the HelloBaby official webсайт или через розничного продавца, у которого вы приобрели товар.

© 2026 HelloBaby. All rights reserved.