1. Введение
This manual provides instructions for the GoolRC Flysky FS-i6X 2.4GHz 10CH RC Transmitter and FS-iA6B Receiver. This system utilizes AFHDS 2A technology, offering robust interference protection, low power consumption, and high receiver sensitivity. It supports data reception from various sensors and servo calibration, making it suitable for RC drones, airplanes, and helicopters.
Figure 1: GoolRC Flysky FS-i6X Transmitter and FS-iA6B Receiver.
2. Что в коробке
В комплект входят следующие компоненты:
- FS-i6X Remote Controller
- Приёмник FS-iA6B
- Привязать штекер
- Руководство
Figure 2: Package contents including the FS-i6X transmitter, FS-iA6B receiver, bind plug, and manual.
3. Настройка
3.1. Initial Setup and Binding
Follow these steps to set up your FS-i6X transmitter and bind it with the FS-iA6B receiver:
- Remove the FS-i6X transmitter from its packaging.
- Insert 4 AA batteries into the transmitter.
- Включите передатчик.
- Connect the bind plug to the receiver's B/VCC port.
- Power on the receiver. The LED on the receiver should flash rapidly, indicating it is in binding mode.
- На передатчике нажмите и удерживайте кнопку КЛАВИША ПРИВЯЗКИ while powering it on. The transmitter display will show "Binding...".
- Once the binding is successful, the transmitter display will show "RX Bind OK" and the receiver's LED will turn solid.
- Remove the bind plug from the receiver. The receiver is now bound and ready for use with the transmitter.
- Select the desired model type (Fixed-Wing/Glider/Helicopter) and channels (6-10) on the transmitter as per your model's requirements.
Video 1: Demonstrates the binding process for the Flysky FS-i6X RC Transmitter with the FS-iA6B Receiver. This video shows how to connect the bind plug, power on the receiver and transmitter, and confirm successful binding.
3.2. Передатчик сверхуview
Familiarize yourself with the various components of the FS-i6X transmitter:
Figure 3: Labeled diagram of the FS-i6X transmitter, showing the antenna, handle, VRA/VRB, switches A/B/C/D, joysticks, fine-tuning rods, UP/DOWN buttons, Bind Key, OK/Cancel buttons, Power button, and LCD display.
4. Инструкция по эксплуатации
4.1. Базовый контроль
Use the joysticks to control your RC model. The left joystick typically controls throttle and rudder, while the right joystick controls aileron and elevator, depending on your chosen mode (Mode 1 or Mode 2).
4.2. Channel Expansion and Firmware
The FS-i6X supports firmware upgrades to expand the number of available channels. Refer to the official Flysky website for the latest firmware and instructions on how to perform updates.
4.3. Sensor Data and Telemetry
The system is capable of receiving data from various external sensors (e.g., temperature, altitude) and displaying it on the transmitter's LCD screen. This telemetry feature provides real-time information about your model.
Figure 4: The FS-iA6B receiver, illustrating its compact design and connection ports for servos and sensors. This image also highlights the dual-gain antenna for stable signal transmission.
5. Техническое обслуживание
- Уборка: Для очистки передатчика и приемника используйте мягкую сухую ткань. Избегайте использования растворителей или абразивных чистящих средств.
- Хранилище: Храните передатчик и приемник в прохладном, сухом месте, вдали от прямых солнечных лучей и экстремальных температур. При длительном хранении извлеките батарейки.
- Уход батареи: Ensure fresh batteries are used for optimal performance. Replace batteries when the low voltagСрабатывает сигнализация.
- Проверка антенны: Regularly check the receiver antennas for any damage or kinks. Ensure they are positioned correctly for best signal reception.
6. Поиск Неисправностей
| Проблема | Возможная причина | Решение |
|---|---|---|
| Передатчик не включается. | Низкий заряд или полная разрядка батарей; неправильная установка батарей. | Replace batteries with fresh AA batteries; ensure correct polarity. |
| Приемник не является обязательным. | Incorrect binding procedure; bind plug not inserted correctly; transmitter too far from receiver. | Repeat binding steps carefully (refer to Section 3.1); ensure bind plug is fully inserted; keep transmitter and receiver close during binding. |
| Потеря управления во время эксплуатации. | Out of range; interference; low transmitter/receiver battery voltage. | Operate within specified range; check for sources of interference; ensure batteries are fully charged. |
| Сервоприводы не отвечают. | Incorrect servo connection; faulty servo; receiver not powered. | Verify servo connections to the receiver; test with a different servo; ensure receiver has power. |
7. Технические характеристики
7.1. FS-i6X Transmitter Specifications
- Модель продукта: FS-i6X
- Каналы: 6-10 (по умолчанию 6)
- Модели: Fixed wing / Glider / Helicopter / Boat
- Частота беспроводной связи: 2.4ГГц
- Мощность передачи: < 20 дБм
- Беспроводной протокол: АФХДС 2А
- Диапазон: 500 ~ 1500 м (по воздуху)
- Разрешение канала: 4096
- Аккумулятор: 1.5AA * 4
- Отображать: Трансфлективный STN-дисплей, ЖК-матрица 128x64 точек
- Диапазон температур: -10°С ~ +60°С
- Диапазон влажности: 20% - 95%
- Размеры: 174x89x190мм
- Масса тела: 392 г
- Тип антенны: Двойная антенна
- Низкая громкостьtage Тревога: < 4.2 В
- Порт данных: PS/2 (PPM)
- Порт зарядки: Никто
- Онлайн-обновление: Да
- Язык: Китайский и английский
- Сертификация: CE certification, FCC ID: N4ZFLYSKYI6X
7.2. Технические характеристики приемника FS-iA6B
- Модель продукта: FS-iA6B
- Каналы ШИМ: 6
- Частота беспроводной связи: 2.4ГГц
- Беспроводной протокол: АФХДС 2А
- Диапазон: 500 ~ 1500 м (по воздуху)
- Тип антенны: Dual copper tube antenna (150mm * 2)
- Власть: 4.0-8.4В
- РССИ: Поддерживается
- Порт данных: PWM / PPM / I.bus / S.bus
- Диапазон температур: -10°С ~ +60°С
- Диапазон влажности: 20% - 95%
- Онлайн-обновление: Да
- Размеры: 47 * 26.2 * 15 мм
- Масса: 10 г
- Сертификация: CE, RCM, FCC ID: N4ZFLYSKYIA10
Figure 5: Visual representation of the specifications for both the FS-i6X Transmitter and the FS-iA6B Receiver.
8. Информация о гарантии
GoolRC products typically come with a standard manufacturer's warranty. For specific details regarding the warranty period and coverage for your FS-i6X transmitter and FS-iA6B receiver, please refer to the warranty card included in your product packaging or visit the official GoolRC webСохраните чек о покупке для предъявления гарантийных претензий.
9. Поддержка клиентов
For technical assistance, troubleshooting, or any other inquiries, please contact GoolRC customer support. You can often find contact information on the product packaging, the official GoolRC webсайте или через вашего розничного продавца.
Visit the official GoolRC store for more products and information: Магазин GoolRC